Kemppi KempCool 40 Bedienungsanleitung

Operating manualENKempCool40

EN3.4 Temperature control PJ 33When you turn the main switch to position 1, the circulating pump starts. If the temperature of the coolant is higher

EN3.5 Disposal of the machineDo not dispose of electrical equipment with normal waste!In observance of European Directive 2002/96/EC on waste electri

EN6. MAIN CIRCUIT DIAGRAMB1 ow controlM1 pumpM2 fanN1 temperature controllerR1 temperature sensorS1 on/o switchB2 AMP connector (connector to

KEMPPI OYKempinkatu 1PL 13FIN-15801 LAHTIFINLANDTel +358 3 899 11Telefax +358 3 899 [email protected] myynti:Tel +358 3 899 1

OPERATING MANUALEnglish

ENCONTENTS1. Introduction ... 31

EN1. INTRODUCTION1.1 GeneralCongratulations on choosing the KempCool equipment. Used correctly, Kemppi products can signicantly increase the produc

EN1.3 PropertiesDescription and operation principleKempCool 40 is an ecient water cooling device. It is equipped with a fan and a radiator using wat

ENSlide blockHex screwAlarm limit pointer (switch-o-point)Setting the alarm limit for coolant pressure:1. Attach the water hoses to the cooling wate

EN2. INSTALLATION2.1 Connecting the cooling systemFill the coolant container through the lling tube. When the maximal level is reached, the built-i

EN3.2 TroubleshootingProblem Cause ActionInsufficient cooling capacityThe heat exchanger and/or air lter is dirty. Clean the components.Clean the co